28
Section 3: Operating Instructions
RC3615 (540 RPM) and RCM3615 (1000 RPM) Rotary Cutters 330-502M
4/20/15
You will need to maintain either 540 or 1000 rpm PTO
speed and 2 to 5 mph ground speed to produce a clean
cut. Make a tractor gear and range selection that will
enable you to maintain these speed combinations.
Generally the quality of cut is better at lower ground
speeds. Dense ground cover will create the need to slow
down even more. In certain conditions tractor tires will roll
grass down resulting in an uneven cut when the grass
fails to rebound. Should this happen you may try
reversing the direction of cut and/or double cut to achieve
the desired finish. Avoid very low cutting heights
especially on extremely uneven terrain. Always cut
downward on slopes and avoid crossing the face of steep
slopes. Avoid sharp drops and cross diagonally through
dips to prevent hanging up the tractor and cutter. Slow
down in turns and avoid sharp turns if at all possible.
Remember to look back often.
Now that you’re prepared and well briefed you may begin
cutting. Begin cutting by doing the following:
•
Reduce tractor’s engine rpm.
•
Make sure cutter wings are on the ground and in
cutting position.
•
Engage PTO, raise engine rpm to the appropriate PTO
speed, and begin mowing.
Operators of models with a conventional main driveline
must plan ahead and choose a cutting pattern that allows
for wider turns. Try increasing or decreasing ground
speed to determine the effect on quality of cut. With a
little practice you will be pleased with what you and your
Land Pride 15' Smooth Top Cutter can do.
When you are done mowing, need to take a break, or just
need to make a few adjustments to the cutter, remember
to always do the following:
•
Reduce tractor’s engine rpm and disengage PTO.
•
Stop on level ground, set park brake, turn off engine,
remove switch key, and stay on the tractor until cutter
blades have come to a complete stop.
