Section 4: Options & Accessories
11/2/18
29
10. Red wires in connectors (#1A & #1B) are attached to
pin “D”. Plug connectors (#1A & #1B) together.
11. Yellow wires in connectors (#2A & #2B) are attached
to pin “B”. Plug connectors (#2A & #2B) together.
12. Route wire harnesses (#17 & #18) to enhance
module (#19). Plug connectors at the enhance
module to harness (#17 & #18) as follows:
a. Red wires in connectors (#1C & #1D) are
attached to pin “B”. Plug connectors (#1C & #1D)
together.
b. Yellow wires in connectors (#2C & #2D) are
attached to pin “C”. Plug connectors (#2C & #2D)
together.
13. Attach connector (#3A) to connector (#3B) on lead
wire harness (#20).
14. Route lead wire harness through spring hose
loop (#22) and connect to tractor 7-way round pin
receiver.
15. Start tractor and operate lights to verify hook-up is
operating properly:
a. Step on the brakes to verify red lights illuminate.
b. Operate turn single to turn right. Amber light on
the right side should blink on and off.
c. Operate turn single to turn left. Amber light on the
left should blink on and off.
16. If the lights did not operate properly, recheck hook-up
of wirer harnesses (#17 & #18). Make necessary
changes to the harnesses and repeat step 15 above.
17. Recheck wire harness routing to make sure wires will
not be pinched as wing decks are folded and
unfolded and while raising and lower cutter height.
18. Add cable ties (#5) to wire harnesses (#17, #18, &
#20) as needed to secure them in place.
NOTE: Refer to Detail B:
Pins in the connectors
are labeled A, B, C, & D. Match yellow and red wires
with same pin letters when attaching wire harness to
light assemblies (#3 & #4) & enhance module (#19).
NOTE:
Route wire harnesses (#17, #18, & #20) in
locations that will not pinch the harnesses as the
deck is raised and lowered and as the wings are
folded up and down.
