28
Section 2: Operating Instructions
NTS2607, NTS2609, & NTS2611 No-Till Seeder 329-141M
9/10/20
Level Seeder With Pull Hitch
1. Transport to the field with seeder attached. For
detailed instructions, see
26.
2. Park seeder on solid, level ground and raise the
seeder fully up.
3. Without changing height of implement, shut tractor
down before dismounting. Refer to
Refer to Figure 2-8:
4. Remove wire retaining pins (#10), transport
locks (#11), and stroke control spacers (#9) from all
three hydraulic lift cylinders and store on nearby
storage racks as shown. Secure transport locks to
storage racks with wire retaining pins (#10).
5. Start tractor and lower seeder to the ground using
factory float. Keep tractor hydraulic lever in factory
float while seeding.
6. Pull ahead 15 feet or until both front and rear rollers
are fully engaged in the ground and then stop.
7.
Without changing height of implement, shut tractor
down before dismounting. Refer to
Refer to Figure 2-8:
8. Place a level (#19) on the mainframe from front to
back to verify frame is level (parallel) with the ground.
9. If frame is not parallel with the ground, unhook tractor
from seeder as follows:
a. Attach park jack (#14) to jack mount (#16) with
detent pin (#13). Insert detent pin horizontally as
shown. Make sure detent pin is fully inserted.
IMPORTANT:
Front spike rollers will not function
properly unless the frame is level with the ground.
IMPORTANT:
Always operate seeder with transport
wheels on the ground and seeder level to prevent
dirt build-up and seeder damage.
Align Clevis With Tractor Drawbar
Figure 2-8
39057
b. Extend jack (#14) to remove load from tractor
drawbar (#3).
c. Leave hydraulic hoses (not shown) connected to
the tractor unless they are too short to allow the
tractor to moved forward 6" without the seeder
attached to the tractor. If hydraulic hoses are too
short, then disconnect the hoses from the tractor
as follows:
•
Move hydraulic control lever back and forth
several times to release all hydraulic pressure.
•
Disconnect hydraulic hoses from the tractor and
store coupler ends on the seeder frame to keep
dirt off them.
d. Unhook safety chain (#12) from the tractor.
e. Unhook seeder from the tractor drawbar by
removing hitch pin keeper (#5), hitch pin (#6), and
flat washers (#1A & #1B). Be careful not to lose
washers, hitch pin, and hitch pin keeper.
f. Start tractor and drive forward until drawbar (#1) is
removed from clevis (#2). If hydraulic hoses are
attached, be careful not to pull them tight.
g. Shut tractor down before dismounting. Refer to
10. Adjust park jack (#14) up or down until the seeder’s
main frame is level (parallel) with the ground.
11. Check clevis hitch (#2). The clevis plates should be
in line with the drawbar. If not, then readjust clevis
hitch height up or down as follows:
a. Remove nylock nut (#17) and bolt (#18).
b. Move clevis (#2) until the clevises upper and lower
plates are parallel with the tractor drawbar.
c. Attach clevis (#2) to hitch channel (#16) with
existing 1"-8 x 6" GR5 bolt (#18) and nylock
nut (#17). Draw nylock nut up snug. Do not
tighten.
IMPORTANT:
Clevis (#2) should be in line with the
tractor drawbar during field operation to reduce wear
on the drawbar.