Land Pride NTS2607, Руководство оператора

Страница: 30 / 78

26
Section 2: Operating Instructions
NTS2607, NTS2609, & NTS2611 No-Till Seeder 329-141M
Table of Contents
9/10/20
15. Refer to Figure 2-7 on page 27: Remove slow
moving vehicle sign (#5) from the back of the seeder
and insert it in the mounting socket on the back of the
tractor.
Install Transport Locks & Spacers
Refer to Figure 2-5:
1. Park seeder hitched to a tractor on level, solid
ground. Place tractor in park or set park brake.
2. Using the tractor hydraulic control lever, raise seeder
until hydraulic lift cylinder (#7) is fully extended.
3. Shut tractor off and remove switch key before
dismounting.
4. Remove stroke control spacer (#4B) from storage
rack (#1) and attach it to cylinder rod (#7A).
5. Remove wire retaining pin (#3) and transport
lock (#2) from storage rack (#1) and attach it to
cylinder rod (#7A) above stroke control spacer (#4B).
Refer to Figure 2-6:
6. Repeat steps 2-5 to install spacers (#4A & #4B) and
transport locks (#2) on the rear cylinder rods (#7A).
7. Start tractor, and lower seeder down until seeder is
resting on transport locks (#2) and stroke control
spacers (#4A & #4B).
Transporting
WARNING
!
To avoid serious injury or death:
•
Always raise implement and set transport locks before
transporting from one work site to another and before
traveling on public roadways. The implement can lower if
not secured in the up position with transport locks.
•
Reduce ground speed when turning and leave enough
clearance to avoid making contact with obstacles such as
buildings, trees, fences, etc. Making contact can result in
equipment damage and cause serious injury or death.
•
Select a safe ground speed when transporting. Never travel
at a speed which does not allow adequate control of steering
and stopping, and never exceed 20 mph (32.2 km/h) with
attached equipment. Rough terrain requires a slower speed.
•
Do not operate and/or travel across inclines where tractor
and/or implement can rollover. Consult your tractor’s
manual for acceptable inclines the tractor is capable of
traveling across.
•
Transport on public roadways with the tractor’s slow
moving vehicle sign mounted on the back of the implement.
It is possible for the implement to block viewing of the sign
by approaching vehicles if mounted on the tractor.
•
When traveling on roadways, travel in such a way that
other vehicles may pass you safely. Always use LED lights,
clean reflectors, and a slow moving vehicle sign that is
visible from the back to warn operators in other vehicles of
your presence. Always comply with all federal, state, and
local laws.
•
When implement is wider than the tractor, take care to make
sure it does not make contact with oncoming traffic and
roadside obstructions.
Front Transport Lock
Figure 2-5
Rear Transport Locks
Figure 2-6
73363
73364