Page 22
PipeCheck
information
Shows the current firmware version and
the status of the SD memory card.
The sound for closed measuring loops at
single measurement (see page 13) can be
toggled by pressing the soft key „
“
resp. „
“.
You may switch from „
” to „
” =
Quickstart
with the middle key.
Pressing the „
“ soft key calls up the information home screen.
Quickstart
In Quickstart mode the
PipeCheck
plus
remembers the area in which it was last
used. After switching off and later on again, it starts again in exactly this area.
The last measuring method used is retained and the device does not carry out
any calibration. So it is ready for use more quickly.
Sensor wire information
Shows the resistance value for the sensor
wire set on the device in
Ω
/m.
Pressing the “+” or “-” soft keys increases
or decreases the resistance value.
Pressing the „
“ soft key stores the
changes and calls up the information home
screen.
Important!
Once the
PipeCheck
plus
device has been switched off, the resistance
value automatically resets itself to the factory setting of 5,8
Ω
/m
since other values represent a significant exception.
The resistance value for the sensor wire is important for accurate calculations of
the measuring section length.
Select sensor type
(only if Quickstart is activated)
On the screen the desired sensor or cali-
bration can be selected by moving the cur-
sor „
“ with the „
“ soft key.
Pressing the "OK" soft key selects the
menu item.
