Page 15
Press the “Stop” soft key to end the
measurement and freeze the display.
Displayed are:
a->F
Distance
start of the measuring wire
- fault
in % and m
F<-b
Distance
fault - end of the measu-
ring wire
in % and m
Sum
Total length of the
measuring wire
in % and m (values that deviate from
100% are the result of rounding tolerances).
Once the measurement has been completed, the measured values can be sto-
red on the SD card in the “F-ORT.CSV” file by pressing the “Save” soft key.
--> See chapter “How to save measured values” on page 17.
Manual measurements
The
PipeCheck
plus
now continuous to perform the currently selected measure-
ment and then displays the measurement result.
Press the right „
“ soft key to switch to the next measurement for
manual fault location.
For all measurements the right-hand vertical bar shows whether the measured
value is stable „
“ or whether it is subject to upward „
“ or downward „
“
fluctuations. This would indicate faults on the measuring section.
The following measurements
can be performed one after another:
R-Iso
Insulation resistance
(Home screen)
The bar chart below the measured
value shows the measured value in
relation to the full scale value of the
measuring scale.
R-Loop
Loop resistance
The bar chart below the measured
value shows the measured value in
relation to the full scale value of the
measuring scale.
