lancer Flavor Select 30, Инструкция по установке и обслуживанию

Страница: 29 / 40

29
P.N. 28-0558/04
TROUBLE CAUSE REMEDY
CONTINUED ON NEXT PAGE
4.15 Water only dispensed, no
syrup. Or syrup only dispensed,
no water.
CONTINUED
E. Stalled or inoperative BIB
pump.
F. Kinked line.
G. CO
2
regulator malfunction.
H. Defective LFCV module.
E. Check CO
2
pressure and/or
replace pump.
F. Remove kink or replace line.
G. Repair or replace CO
2
regulator as required.
H. Replace module.
4.16 Valve will not shut off. A. Debris in solenoid seat.
B. Solenoid plunger sticking.
A. Activate valve a few times to
free debris. Remove the solenoid
coil and plunger. Clean out any
foreign material.
B. Replace solenoid coil.
4.17 Syrup only dispensed. No
water, but CO
2
gas dispensed
with syrup.
A. Improper water flow to
dispenser.
B. Carbonator pump motor has
timed out (a message will be
displayed on the LCD screen).
C. Liquid level probe not
connected properly to PCB.
D. Defective PCB assembly.
E. Defective liquid level probe.
F. Weak or defective carbonator
pump.
A. Check for water flow to
dispenser.
B. Reset by turning the unit OFF
and then ON by using the circuit
breaker on the power supply or
momentarily unplugging unit.
C. Check connections of liquid
level probe to PCB assembly.
D. Replace PCB assembly.
E. Replace liquid level probe.
F. Replace pump.
4.18 Excessive foaming. A. No ice in bin.
B. Incoming water or syrup
temperature too high.
C. CO
2
pressure too high.
D. Water flow rate too high.
E. Nozzle and diffuser not clean.
F. Air in BIB lines.
A. Fill bin with ice and allow
coldplate to re-stabilize.
B. Correct prior to dispenser.
C. Adjust CO
2
pressure
downward, but not less than 70
PSI.
D. Re-adjust and reset ratio.
E. Remove and clean.
F. Bleed air from BIB lines.