Lance Truck Camper, Руководство пользователя

Страница: 51 / 112

51
battery after the truck battery has reached 13.2 volts. If
the drain on the truck battery is reduced below 12.8
volts, the Battery Separator will disconnect the truck
battery from the camper circuit, thus protecting the
truck battery from excessive drain.
BATTERY DISCONNECT SWITCH
SYSTEMS MONITOR PANEL
The systems monitor panel may incorporate controls
and instrumentation for the water and holding tank
levels, battery voltage level, water pump, water
heater ignition, generator start and hour reading.
WATER PUMP CONTROL SWITCH
This rocker switch controls the demand water pump.
The water pump is pressure sensitive and starts (with
the switch ON) when a faucet is open, causing
pressure in the line to drop. When the faucet is
closed, pressure builds in the line and the pump
stops.
MONITOR PANEL - LEVEL INDICATOR SWITCH
When depressing the monitor switch, indicator lights
for the black (waste), grey (sink) and fresh water tank
will illuminate, indicating the existing condition of
each component. The battery level is a digital display
that reflects the battery voltage when the switch is
depressed.
Erroneous indications when checking water levels
can be caused by:
Water with low mineral content. Level is
measured by a very low electrical signal
traveling through the liquid. Some water that
is low in mineral content may not conduct the
signal properly. This condition may be
47
EXTERIOR LIGHT FUSE BOX 12-volt and Main Circuit
Breaker
The fuse box contains fuses and a 40-amp circuit
breaker that feeds power from the truck to the camper
fuse panel, refrigerator, jacks, exterior lights and
battery. When an overload or short circuit occurs, this
breaker will not allow power from the truck into the
camper.
The fuse box is located in the forward driver side front
corner of the main floor. Circuit titles and fuse sizes are
labeled.
To reset the breaker, disconnect and then reconnect the
power connector to the truck. If the breaker continues
to trip, a short circuit or overload condition is indicated.
Have the system checked by your Lance dealer.
CAMPER FUSE PANEL 12-volt Interior Circuits
A 12-volt interior fuse panel is installed in the Power
Distribution Center to protect the interior circuits.
Circuit
infrequent, but can exist. Check the panel
reading when the fresh water tank is filled.
Material trapped on the sides of the holding
tanks may give a full reading when the tank is
actually empty. Use of a spray to wash out the
tank following dumping should help prevent
this condition.
NOTE: If the sensor probes mounted in the tanks get
coated with grease, the monitor panel may indicate
falsely or not at all. Avoid pouring grease, oils, or
similar substances down drains or the toilet. If this is
unavoidable, the holding tank(s) should be washed out
with a soapy water solution.
battery after the truck battery has reached 13.2 volts. If
the drain on the truck battery is reduced below 12.8
volts, the Battery Separator will disconnect the truck
battery from the camper circuit, thus protecting the
truck battery from excessive drain.
BATTERY DISCONNECT SWITCH
SYSTEMS MONITOR PANEL
The systems monitor panel may incorporate controls
and instrumentation for the water and holding tank
levels, battery voltage level, water pump, water
heater ignition, generator start and hour reading.
WATER PUMP CONTROL SWITCH
This rocker switch controls the demand water pump.
The water pump is pressure sensitive and starts (with
the switch ON) when a faucet is open, causing
pressure in the line to drop. When the faucet is
closed, pressure builds in the line and the pump
stops.
MONITOR PANEL - LEVEL INDICATOR SWITCH
When depressing the monitor switch, indicator lights
for the black (waste), grey (sink) and fresh water tank
will illuminate, indicating the existing condition of
each component. The battery level is a digital display
that reflects the battery voltage when the switch is
depressed.
Erroneous indications when checking water levels
can be caused by:
Water with low mineral content. Level is
measured by a very low electrical signal
traveling through the liquid. Some water that
is low in mineral content may not conduct the
signal properly. This condition may be
47
EXTERIOR LIGHT FUSE BOX 12-volt and Main Circuit
Breaker
The fuse box contains fuses and a 40-amp circuit
breaker that feeds power from the truck to the camper
fuse panel, refrigerator, jacks, exterior lights and
battery. When an overload or short circuit occurs, this
breaker will not allow power from the truck into the
camper.
The fuse box is located in the forward driver side front
corner of the main floor. Circuit titles and fuse sizes are
labeled.
To reset the breaker, disconnect and then reconnect the
power connector to the truck. If the breaker continues
to trip, a short circuit or overload condition is indicated.
Have the system checked by your Lance dealer.
CAMPER FUSE PANEL 12-volt Interior Circuits
A 12-volt interior fuse panel is installed in the Power
Distribution Center to protect the interior circuits.
Circuit
infrequent, but can exist. Check the panel
reading when the fresh water tank is filled.
Material trapped on the sides of the holding
tanks may give a full reading when the tank is
actually empty. Use of a spray to wash out the
tank following dumping should help prevent
this condition.
NOTE: If the sensor probes mounted in the tanks get
coated with grease, the monitor panel may indicate
falsely or not at all. Avoid pouring grease, oils, or
similar substances down drains or the toilet. If this is
unavoidable, the holding tank(s) should be washed out
with a soapy water solution.
battery after the truck battery has reached 13.2 volts. If
the drain on the truck battery is reduced below 12.8
volts, the Battery Separator will disconnect the truck
battery from the camper circuit, thus protecting the
truck battery from excessive drain.
BATTERY DISCONNECT SWITCH
SYSTEMS MONITOR PANEL
The systems monitor panel may incorporate controls
and instrumentation for the water and holding tank
levels, battery voltage level, water pump, water
heater ignition, generator start and hour reading.
WATER PUMP CONTROL SWITCH
This rocker switch controls the demand water pump.
The water pump is pressure sensitive and starts (with
the switch ON) when a faucet is open, causing
pressure in the line to drop. When the faucet is
closed, pressure builds in the line and the pump
stops.
MONITOR PANEL - LEVEL INDICATOR SWITCH
When depressing the monitor switch, indicator lights
for the black (waste), grey (sink) and fresh water tank
will illuminate, indicating the existing condition of
each component. The battery level is a digital display
that reflects the battery voltage when the switch is
depressed.
Erroneous indications when checking water levels
can be caused by:
Water with low mineral content. Level is
measured by a very low electrical signal
traveling through the liquid. Some water that
is low in mineral content may not conduct the
signal properly. This condition may be
47
EXTERIOR LIGHT FUSE BOX 12-volt and Main Circuit
Breaker
The fuse box contains fuses and a 40-amp circuit
breaker that feeds power from the truck to the camper
fuse panel, refrigerator, jacks, exterior lights and
battery. When an overload or short circuit occurs, this
breaker will not allow power from the truck into the
camper.
The fuse box is located in the forward driver side front
corner of the main floor. Circuit titles and fuse sizes are
labeled.
To reset the breaker, disconnect and then reconnect the
power connector to the truck. If the breaker continues
to trip, a short circuit or overload condition is indicated.
Have the system checked by your Lance Dealer.
CAMPER FUSE PANEL 12-volt Interior Circuits
A 12-volt interior fuse panel is installed in the Power
Distribution Center to protect the interior circuits. Circuit
infrequent, but can exist. Check the panel
reading when the fresh water tank is filled.
Material trapped on the sides of the holding
tanks may give a full reading when the tank is
actually empty. Use of a spray to wash out the
tank following dumping should help prevent
this condition.
NOTE: If the sensor probes mounted in the tanks get
coated with grease, the monitor panel may indicate
falsely or not at all. Avoid pouring grease, oils, or
similar substances down drains or the toilet. If this is
unavoidable, the holding tank(s) should be washed out
with a soapy water solution.
WATER HEATER IGNITION SWITCH
Your camper is equipped with a dual power
(propane/120 volt) water heater with direct spark
ignition (DSI). It will have a DSI switch to ignite the
propane heater and a 120 volt switch to turn on the
electric heating element in the water heater.
MONITOR PANEL - LEVEL INDICATOR SWITCH(S)