STARTING HOT ENGINE
For several minutes (10 to 45) after stopping a hot engine, heat soaked
fuel injection components, (especially the fuel injection pump) may
cause vaporization of fuel in the components resulting in difficulty
restarting the engine. To eliminate this difficulty, the following
procedures must be used to cool the fuel pump and lines prior to restart.
1 Alternate
Air
CLOSED
2
Mixture
IDLE CUT OFF
3
Propeller
HIGH RPM
5 Throttle
CLOSED
6
MASTER Switches
MASTER ON then AUX ON
7 Lights
ON as required
8
Boost Pump
ON FOR 3 TO 5 SECONDS
THEN OFF
9
Wait a few seconds
Allow all fuel to drain from
intake system
10 Mixture
RICH
11
PRIME button
PUSH IN (Approximately 3
seconds)
12
Throttle
CLOSED, THEN OPEN ¼
INCH
13 Propeller
Area
CLEAR
14
Ignition Switch
START (release when engine
starts)
NOTE
It may be necessary to leave the boost
pump on during starting and turn it off
approximately one minute after engine
start
15
Throttle
IDLE (900 to 1000 RPM)
16
Oil Pressure
CHECK (30 to 60 PSI)
NOTE
After starting, check for oil pressure
indication within 30 seconds. If no
indication appears, shut off engine and
investigate.
AFTER ENGINE START
1
PFD Annunciations
CHECK CLEAR
Содержание ES-P
