_____25.
Check engine for loose nuts, bolts, screws, studs, etc.
_____26.
Check engine cowling and baffles: repair when
necessary. Install cowling and check security of installation.
_____27.
Review engine airworthiness directive notes for
compliance.
_____28.
Check general maintenance aid notes applicable to
engine.
TURBOS
_____1. Duct tape the exhaust side of a vacuum into the exhaust
pipe of the engine. Note the vacuum should be cleaned
prior to
this test.
_____2. Check the compressor and turbo housing for leaks. Fill a
spray bottle with water and then put one drop of soap in it.
_____3. Inspect impellers on the compressor for freedom of
movement and condition.
COMPRESSORS
_____1. Duct tape the exhaust side of a vacuum into the
Compressor side of the induction system. Remove the sceet
tubing from the mixer or heat valve. Plug the end of the skeet
tubing. Check the Compressor and induction system for leaks,
also check the bleed air and after coolers for leaks.
PROPELLER GROUP
_____1. Inspect propeller blades for nicks, bends, cracks and
condition of the tips.
_____2. Remove spinner and check for cracks. Check blade
shake, max 1/8 inch. The blade shake must be checked IN
and OPPOSITE the direction of rotation. Measure blade
shake 4 inches from blade tip at the trailing edge.
_____3. Check blade angle play, max 2
o
. If the check shows
values above these tolerances, contact the service
department of MT-Propeller.
Содержание ES-P
