6 Graphical user interface
Issue EN 2022/05 PUK 6 Operating manual
42/56
6.5
Update menu
Fig. 6.9 Update menu
Proceed as follows to update the device software:
1)
Transfer the update file to a USB data carrier. This should have a maxi-
mum of 16 GB memory capacity and be formatted in FAT32 format.
2)
Switch off the welding device on the back of the device.
3)
Insert the USB data carrier into the USB port on the back of the device.
4)
Switch on the welding device on the back of the device.
5)
In the settings menu, select the update button with the rotary-push con-
trol and confirm.
6)
An update window opens as shown in Fig. 6.9. The update can be
started with the "Start Update" button. The progress of the update is
shown in percent on the display.
7)
The device restarts after the update.
8)
You can check whether the software version has been updated correctly
in the update menu.
9)
If the correct software version is installed, remove the USB data carrier.
The device software is now updated.
If the update was not successful, the above steps must be repeated. If the
update did not work even after repeated attempts, please contact customer
service.