Lampert PIP 100, Руководство по эксплуатации

Страница: 9 / 15

9
4-3. ADJUST THE PARAMETER
OPERATION OF MENU AND KEYS
Keep the keys pressed until a beep signal confirms the input.
If a key is pressed continuously this is to rate as renewed
key/input.
With the keys < and > the individual menu points (program fields) can be selected.
Using the + and - key the desired programme can be selected if the programme field is activated.
NOTE: To reach the most quickly possible welding sequence no menu option may be selected!
I.e. keep the keys < / > pressed until no menu option is active anymore or store you the selected setting.
PROGRAMME STORING
Through pressing the „S" - key the memory procedure is activated.
Now a program place of 1 - 20 can be selected by using the + and - key
Using the < or > key the memory procedure can be discontinued.
The „S“– Key needs to be pressed again for 2 seconds to close the memory procedure.
With release the S - key the current parameters are stored into the selected program place.
SELECTION OF WELDING TENSION
Different welding tensions can be selected in the menu „charge“.
Charge Welding Tension in V
1 38
2 39,5
3 40,5
4 41,5
5 43
The welding tension affects the ignition behaviour and the amount of energy.
SELECTION OF IMPULSE SHAPE
The current welding process can be affected in the menu "pulse".
Current process Pulse shape
1 Standard impulse
2 Rise and descent flattened
3 Descent flattened ( 2/5 of the welding time)
4 Rise flattened (3/5 of the welding time)
5
Descent flattened (4/5 of the welding time)
6 Rise (1/5)and descent (2/5) flattened
NOTE: If a pulse length is selected smaller than 7ms, always the plus form 1 is active!