6
GENERAL WARNINGS
ELECTRICAL POWER SUPPLY
- The electrical safety of the burner is achieved only when it is properly connected to an efficient
earthing system in accordance with the safety regulations in force.
- This fundamental safety requirement must be verified. In case of doubt, have professionally qua-
lified personnel carefully inspect the electrical system. The manufacturer is not responsible for any
damage caused by failure to earth the system.
- Have professionally qualified personnel check that the electrical system is suited to the maximum
power absorbed by the machine as indicated on the plate, and in particular, that the cross-section
of the system cables is suited to the power absorbed by the machine.
- It is not permitted to use adapters, multiple sockets and/or extensions for the mains power supply
of the machine.
- Fit an omnipolar switch for the connection to the mains in accordance with the safety regulations
in force.
- The use of any component that utilizes electrical energy implies observance of some fundamental
rules, such as:
- Do not touch the machine with wet or moist parts of the body and/or with bare feet.
- Do not pull on the electric cables.
- Do not leave the machine exposed to atmospheric agents (rain, sun, etc.) unless specifically othe
rwise specified.
- Do not allow children or inexpert persons to operate the machine.
- The power cable of the machine may not be replaced by the user. If the cable is damaged, switch
off the machine and have professionally qualified personnel replace it.
- If you decide not to use the machine for a certain period of time, disconnect the electrical power
switch to all the system components that use electrical energy (pumps, burner, etc.)
GAS, DIESEL OIL OR OTHER FUELS
General warnings
- The burner must be installed by professionally qualified personnel in conformity with the regulat-
ions and provisions in force. Incorrect installation may cause damage to persons, animals or
things for which the manufacturer cannot be held responsible.
- Before installation, it is advisable to thoroughly clean the inside of all the fuel feed pipes in order
to remove any residues which might compromise good functioning of the burner.
