-
122
-
Huracán ST
– Rear Suspension Assembly
Vehicle Introduction
® Automobili Lamborghini S.p.A.
The procedures and information published herein are strictly confidential and are intended exclusively for recognized professionals and persons who are authorized to receive said
information. All copyrights are the property of Automobili Lamborghini S.p.A pursuant to copyright law. All PDF chapters comprising the WEB workshop manuals described herein are based
on information that were available at the time of publication. The company reserves the right to make updates and modifications as needed. The reprinting, reproduction, distribution to
unauthorized persons and/or to third parties, and the partial or complete translation of the material contained herein are prohibited without the express written consent of Automobili
Lamborghini S.p.A. Huracán ST
Rear suspension
Pre-assembly
Procedure applies to both sides, LH and RH
Clean all threads with degreaser
1
Place the rear hub housing in a vise
Position the hub-bearing assembly on
the hub housing.
Bring the 4 mounting screws into
position.
Install the 4 screws
Tightening torque to 80Nm+90°
2
Position the rev sensor and fasten it
to the hub housing with screws.
Install the screw
Tightening torque 6Nm
3
Position the upper arm on the hub
housing and bring the fastening nut
into position
Position the lower arm on the hub
housing and bring the fastening nut
into position
Tighten the 2 nuts
Tightening torque 140Nm