lamber LP8/L-dy, Инструкция по эксплуатации

Страница: 12 / 48

12
Attention : during tank filling don’t open the door
of the machine!
Attention!
If during the loading phase, appears the message
“BREAK TANK”, this means that you’re filling up
with water the rear Break Tank.
If after 5 minutes the data is still flashing in
alternation with the inscription FILLING PHASE 1,
you will see the word ALARM BEREAK TANK and
this will means that there may by a problem in the
tank loading. (Call the Technical Assistance
Service!)
At the end of the filling phase of the tank on the
interactive display will appear the following
information (from left to right):
-Temperature of washing;
-Time of washing;
-Number of cycle;
-Temperature of rinsing..
The data of the temperature Tank and Boiler,
flashes slowly and increases in value, indicating
the current warming of the water in the boiler.
When temperature has reached, the data stops
flashing.
Attention !
The machine is programmed at the factory so you
can start the washing programm after filling the
tank up to the required level.
However, before you start the cycle, make sure
that the machine has reached the ideal
temperature range (55°C for washing and 85°C
for rinsing):
In any case, the rinse will start only in
temperature regime reached. The duration of the
washing time chosen will then be continued until
it reaches the set temperature (
(Thermocontrol).
WASHING
3
- Open the door of the machine and insert
the basket. .
N.b.The display informs you when the top of the
machine is open.
4
- Place the objets in the basket minding to
previously remove all solid waste and fat.
N.B .: When the objects to be washed present
burnt crusts, or a long time is elapsed from
cooking up tothe time of washing, it is necessary
to make a previous softening in water at 50°C,
by using an appropriate softening product.
For a correct positioning of the objets see the
specific paragraph on page 17.
5
- Select the time of the washing cycle by
pressing the time selection
“D”
,
According to the following criteria:
- cycle 1 :
short 2 minutes ;
- cycle 2 : intermediate 3 minutes ;
- cycle 3 : long 4 minutes ;
- cycle 4 : infinite 15 minutes ;
The duration of the cycle must be chosen
according to the type of dirt to be removed from
the objets.
See paragraph specifically for custom
programming, in the section dedicated to the
installer
.
6
- Close the door of themachine .
Start at this point the washing cycle of the
chosen duration comprising in addition to washing
a rest period of 5 seconds, and a rinsing phase
lasting 15 seconds with clear water at 85°÷90°C.
(only for machines with steam condenser
CVP-S)
At the end of the washing phase there is the
automatically activating of the fan for suction of
the vapors. This aspiration continues for a
programmable time from 0” a 60” beyond the end
of the rinse seconds ( default 20“) .
A beep indicates the end of the cycle.
(only for machines with steam condenser CVP-S)