lamber LP8/L-dy, Инструкция по эксплуатации

Страница: 11 / 48

11
First Section - FOR THE USER
WORKING AND USE
NOTE:
- When the objects to be washed present burnt crusts, or a long time is elapsed from cooking up to the
time of washing, it is necessary to make a previous softening in water at 50°C, by using an appropriate
softeningproducts;
- Never deep naked hands in detergent water;
- While the machine is running, never open the door too rapidly;
- Only use specific anti-frothing detergents.
INSTRUCTIONS BEFORE WASHING
B
EFORE STARTING THE WORKING OPERATION MAKE
SURE THAT
:
- the cock is open;
- the filters and the overflow are in
their housings;
- the wash arm and the rinse arm are free to
pivot;
- rinse aid and washing powder dispenser
containers are loaded.
T
HEN PROCEED
:
1
- Put the detergent directly into the tank, by
paying attention to distribute it uniformly
on the filters, the quantity being according to
supplier's instructions.
N.B. When using chlorinated detergent, it is
suggested to use an automatic dispenser; if
otherwise, brownish spots might appear on the
surfaces, because of chlorine reactions, if
powering the detergent directly in the tank.
CAUTION : Observe the safety notes and
dosage data for the use of chemicals. During
the use of the chemical substance wear
protective clothing, gloves and protective
glasses. Do not mix different cleaning
products.
TURN ON THE MACHINE and
operating state of emergency.
2
- Turn on the power using the switch on the
wall and press the switch "A" placed on the
control panel (DIAGRAM.1).
You will see the serial number of the machine
followed by the logo Lamber.
Please pay attention to the opening and
closing of the door of the machine. Do not use
the machine if you are wearing clothes/items
that could get entangles in the machine parts.
As they can limit personnel’s regular moving
ability!
Close the door of the machine.
Press at this point the key switch “A” on the
control panel (draw 1)
At this point the LED will turn green and the
interactive display will show “Fill phase 1” that will
signal the start of the filling phase of the tank.
The filling phase is implemented in two stages.
In STEP 1 begins the load of the tank with water
from the water mains; in STEP 2 continues the
filling but also begins a warm-water washing.
Note: If the machine is equipped with water
softener, during the FILLING PHASE 1 it will be
made to one or more cycles of Regeneration and
a subsequent Resins’ Washing.