lamber LP6-dy, Инструкция по эксплуатации

Страница: 15 / 52

15
(N.B. The word “REMOVE OVERFLOW” will
disappear only to the closing of the door)
The discharge stops automatically after about
2’,20” minutes.
The discharge can be interrupted at any time by
pressing the cycle-button
“B”
After drainig, the machine will turn off
completely (display OFF).
Replace the overflow into place and close the
door.
EMERGENCY MANUAL DRAIN:
In case of emergency or for any reason, it’s possible to
drain manually the exceeding water from the wash tank.
-1 Open the hood of the dishwasher;
-2 Press the setting button “E”
for 3 seconds and, always keeping pressed this
button, drain the exceeding water as
needed (the message ‘MANUAL DRAIN’
will be displayed). When you release the
button, the drain pump will stop.
ATTENTION: Don’t use this function to drain
completely the dishwasher.
DESCALING (optional)
(only for machine with drain pump and
dispenser )
The descaling function
is a cycle that leads
descaling liquid in the pipelines of rinsing, in the
washing tank and boiler allowing the removal of
limescale deposits from the water products.
The cycle lasts about 35 minutes.
For an average water limestone is recommended
cycle activation at least once a week.
The frequency may vary depending on type of
water.
machine «OFF»
Door
closed
Remove the
overflow
keep
button
pressed
for 3 sec.
keep button
pressed for 3 sec
and w
.
ait the End
of the drain
1
2
3
4
To make the cycle do the following operations:
-1
Punt the machine OFF by pressing the
switch “A” (led off)
-2 Remove the OVERFLOW from the tank;
-3 Press the “B” button for 3 seconds and
wait for the complete emptying of the
tank;
-4 Close the door of the machine;
-5 Then press the “E” button for 3
seconds
At the end of the descaling cycle (approx. 35
minutes) will appear on the LED the words
“END OF THE DESCALING CYCLE”.
AUTOMATIC OFF
The function “Automatic OFF” allows to activate
the automatic switch off of the dishwasher.
If the dishwasher is not used during 1 hour, it
switches off completely (machine OFF), and all
the heating elements are disconnected at the
same time.
To switch on again the dishwasher press the
pushbutton “A”.
To restart the cycle, close the hoor and press the
cycle pushbutton “B”.
Attention! This function can be activated on
demand only by a qualified technician.
See the specific paragraph about the customized
programming, in the section for the installer.
If this function is activated, on the display the
symbol of the clock will appear.
CYCLE REPETITION
It’s possible to program the serial repetition of a
certain number of cycles (up to 50).
The programming can be independently carried
out for every wash cycle.
During the cycle the display will show the
numeration of the cycles sequence (1 of 10, 2 of
10 etc….)
Attention! This function can be activated on
demand only by a qualified technician.
See the specific paragraph about the customized
programming, in the section for the installer.