lamber LP6-dy, Инструкция по эксплуатации

Страница: 17 / 52

17
List ALARMS!
BREAK TANK ALARM
This indicates a fault in the operating system:
lack of water mains, valve not functionning: Call
Customer Service!
Alarm: A3-TEMP.SENSOR
This message indicates that the probe of the tank
temperature
thermostats or boiler is defective.
Call the Technical Support Service!!
Alarm: A2-HIGH TEMP.
This message indicates that the temperature in
the boiler is greater than 105°C.
Call the Technical Support Service!
Alarm: BOILER PROBLEM FAILURE
This message indicates that the probe of the
boiler is not working properly. In this case the
functioning of the resistance of the boiler and the
Thermocontrol are disabled.
Call the Technical Support Service!
Alarm: TANK PROBLEM FAILURE
This message indicates that the probe of the
washing tank is not working properly. It is
disabled in this case the functioning of the
washing tank resistance.
Call the Technical Support Service!
TANK FILLING ALARM
If after 15 minutes the tank filling is not concluded,
the message TANK FILLING ALARM will be
displayed accompanied by an acoustic alarm.
The dishwasher stops working.
Switch off the machine by pressing ON/OFF
pushbutton.
(If possible check before if there is water inside
the network or the overflow is in correct place.)
Call the Technical Support Service!
CHECK THE WATER LEVEL
This message indicates that, during the wash
cycle and every time that the dishwasher fills with
water, an excessive decrease of the water level
inside the tank has occurred.
Check that the water feeding cock is open, or
that the overflow is correctly placed in its
housing.
On the contrary, Call the Technical Support
Service!
TANK HEATING CHECK RINSE
ATTENTION: if the dishwasher is in the washing
phase (pump is functioning), the cycle will stop.
Verify that there is no trace of detergent on the
dishes before to use them.
Call the Technical Support Service!
CHECK TANK HEATING
ATTENTION: if the dishwasher is in the washing
phase (pump is functioning), the cycle will stop.
Verify that there is no trace of detergent on the
dishes before to use them.
Call the Technical Support Service!