lamber LP6-dy, Инструкция по эксплуатации

Страница: 14 / 52

14
STAND BY-ECONOMY
(only available on a machine with automatic
start!):
The s tand-by function allows you to keep the
machine closed at rest, keeping active heating
functions
.
machine «ON»
Door
open
To start cycle
press button
keep
button
pressed
for 3 sec.
1
2
Stand-by : with open door and the machine is in
“ON”, press the cycle “B” push-button for 3
seconds, then closing the door, the machine will
not operate the wash cycle while maintaining
active heating functions.
The display shows the word “ECONOMY”. The
temperature of the heater stabilizes at 60°
reducing the consumption of energy.
Attention!: make sure, after you start the
stand-by function to close the doord to keep
the wash tank hot and not disperse heat!
To restart the cycle, put the door down and press
the push-button
“B” .
Automatic Stand-by : after 10 minuters of non-
use of the machine, with the door open , it
automatically activates the STAND BY-
ECONOMY, (the display shows the word
ECONOMY P*)
To restart the cycle, put the door down and press
the push-button
“B”.
SELF-WASHING
The function of self-washing allows you to make
a cleansing cycle at the inside of the washing
tank.
The inside of the washing tank is cleaned with
water coming from water network.
machine «OFF»
Door
closed
Remove the
overflow
Wait the End
of the drain
(with drain pump
press button)
keep
button
pressed
for 3 sec.
1
2
3
4
-
Self-washing cycle : with the machine ”ON” do
the following operations::
-1
Put the machine OFF by pressing the
push-button “A” ( led off)
-2 Remove the overflow of the tank and wait
until same is empty;
For machines equipped with drain pump, see the
instructions at the specific paragraph.
For machines without drain pump:
Visually check that the tank is empty,
-3
Close the door of the machine ;
-4 Hold the ”
”
button for 3 seconds
.
ATTENTION: before your press the ”
”
, button,
make sure that the display shows the logo lamber
” ”.
In case it is off, turn the machine on by pressing the
switch “A” and then pressing it again to to turn off
again the push button “A”
The logo Lamber will reappear and will then be able to
start the function SELF-WASHING holding down the
select push button ”
”
for 3 seconds
On the display you will see the words “SELF-
WASHING” with the time bar that indicates the
icrease for the duration of the cycle of 5 or 10
minutes depending on the time of rinse set by
default
If you want
to stop the cycle SELF-WASHING, it
is sufficient to press the switch “A”.
DRAIN PUMP INSTRUCTIONS (optional)
(only for machines with drain pump)
The pump discharge function allows you to
automatically download the wash tank at the end
of the workday.
machine«OFF»
Door
open
Remove the
overflow
1
2 3
keep
button
pressed
for 3 sec.
The operation of the discharge pump
is
automatic only during the cleaning cycle to
drain the excess water that enters during the
rinsing phase
At the end of the working day, to discharge
the tank completely,
you must perform the
following steps:
-1
Put the machine OFF by pressing the
switch “A” (the display shows LAMBER
logo);
-2 Open the door of the machine;
-3 Remove the OVERFLOW from the tank
-4 Then press the “B” cycle-button for 3
seconds
Alternately flash the words “DRAIN” and
“REMOVE OVERFLOW”