lamber AA-08101, Инструкция по эксплуатации

Страница: 52 / 68

52
WATER CONNECTIONS
WARNING!
The machine must be connected to the water
mains using new hose-sets. The old hose-
sets should not be reused !
Water
installation must have the following
characteristics:
Temperature
:
10÷12
°C
Dynamic Pressure
:
2 ÷ 4 bar (200÷400 kPa)
1) Connect the end of drain pipe
"S"
(fig.3 -
pag.46) th the drainage shaft.
Drain pipe should have slump to allow the
matters drain; under floor drain pipes should
have a dia. of 80-100 mm.
2) Connect inlet pipe
"E"
(fig.3 - pag.46) to a
3/4" screwed Gas tap .
Make sure there are no throttlings along the
pipe.
The National and Regional Standards existing
on the subject must be rigorously respected.
Parameters’ programming
modification
C
D
B
F
E
A81-ek
START
A
G
1. Make sure that the wall switch is on;
2. Press at the same time buttons
“E“ and
“G“ (“+” and “-“)
and then give power to
the machine by pressing button ‘’A’’ to
position On;
3. Always pressing buttons
“E“ and “G“
(“+” and “-“)
, wait for 3 seconds till on
the display ‘’
FACTORY PARAMETERS
’’
and then ‘’
Language
’’ will appear;
4. Modify the parameter acting on buttons
“E“ and “G“ (“+” and “-“)
to reduce or
increase the parameter value;
5. Press button ‘’C’’ (START) to see in
sequence all the parameters ( look at the
complete list in the following table);
6. To validate the modified parameters’
value, run by button ‘’C’’ (START) till the
last inscription ‘’Press start’’ will appear;
The parameters are stored.
Description Default
(Reset)
Modified
parameters
Language
Italian
French
Spanish
English
German Italian
Time-out
Lev. 1-2 2s DO NOT
MODIFY
Time-out
Lev. 3 30s DO NOT
MODIFY
Rinse cycle
(yes-not) Yes
Total CYCLES ___ Cycles’ meter
RESET Electronic card :
Press at the same time the 3 buttons ‘’B’’, ‘’C’’
and ‘ “+” (‘’E’’) and always pressing them give
power to the machine by pressing button ‘’A’’
to the position On.