5
2.1.1 Wall-Mounting the TPSD2 (4B, 4T, and 9 Enclosures Only)
The
4B, 4T, and 9
enclosures of the TPSD2 are shipped from the factory with the necessary brackets installed
for wall-mounting
(The same bracket is used for rear mounting on a relay rack, 4B, 4T – 19/23” rack, 9 – 23/30”
rack)
The
72 & 44
enclosures do not come with wall mounting equipment, it is not recommended to attempt to
mount these enclosures on any wall.
Wall-Mount Procedure
To wall-mount the TPSD2, install four 0.5 in (12.7 mm) bolts on the wall rated to support the charger weight plus
a safety factor of at least two times. Secure the charger on bolts, add appropriate mounting hardware, and tighten
securely. Refer to the figures below for mounting dimensions and specifications.
NOTE:
All above dimensions are in inches. For further TPSD2 enclosure information, see the outline drawings
for the corresponding enclosures online at
http://www.lamarchemfg.com/info/enclosure-drawings.html
Figure 5 - 9 Enclosure Bolt Pattern
Figure 3 - 4B Enclosure Bolt Pattern
Figure 4 – 4T Enclosure Bolt Pattern
