laguna Sheartec II JX 8, Руководство пользователя, Страница: 33 / 47

JX|8 Sheartec:II Jointer \ Wiring 31
STEP 4: Place straight edge to all the positions shown in FIG. 32 and loosen set screw(s) adjust the eccentric
bushings, as in FIG. 31, until straight edge slightly touches the cutterhead insert knife (at top-dead-center) at each
position.
Figure 32: Checking table
STEP 5 : After verifying the parallelism on the outfeed table, make sure the eccentric collars are seated snugly,
into its bracket, and tighten cap screws with washers and then tighten set screws into eccentric bushings (Fig.
31).
STEP 6 : Remove infeed table “depth stop release knob” and infeed table cover, loosen set screws and place
straight edge across infeed tables as in Fig. 33, and adjust eccentric bushings under infeed table (as in Step 4)
for outfeed table.
STEP 7 : Verify parallelism in each position as in Fig. 33 confirm eccentric bushings are snug and tighten cap
screws and then set screws in eccentric bushings on infeed table.
Figure 33: Verification of parallelism/coplanar
STEP 8:
Tighten cap screws and set screws in eccentric brushings under infeed table.
STEP 9 : Re-install table covers and infeed table depth stop release knob.
NOTE: Confirm the Eccentric Bushings are fully seated (hex collar pushed snug into bracket) and cap
screws are tight, before tightening set screws. This prevents excessive play and side-to-side bed
movement.