laguna Sheartec II JX 8, Руководство пользователя, Страница: 27 / 47

JX|8 Sheartec:II Jointer \ Maintenance 25

TURN OFF AND DISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE OR ADJUSTMENTS!
WARNING

TURN OFF AND DISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE OR ADJUSTMENTS!
WARNING
Outfeed Table Adjustment:
The outfeed table is adjusted at the factory to be level with (or up to max .006” lower than) the Top Dead
Center (TDC) of the knife inserts.
To adjust the Outfeed Table, loosen the Adjustment Lock (Fig. 20) for the Outfeed Table with an 8mm hex
wrench (not included). Adjust the height of the Outfeed Table with the Adjustment Handle for the Outfeed
Table (Fig. 20). Tighten the Adjustment Lock.
FIGURE 20: OUTFEED TABLE ADJUSTMENT
Poly Drive Belt Adjustment:
Proper tension is achieved when the belt can be
depressed approximately 1/2
” mid -way between
the pulleys (1/4” depressed from each side) .
If adjustment is needed remove the four screws
holding the back panel to the stand of the jointer.
FIGURE 25: TWO OF THE FOUR MOTOR MOUNTING BOLTS
FIGURE 21: Motor Mount
The motor is attached with four bolts on a slide. Loosen the four motor mount bolts to tension the drive belt
by sliding the motor downward.
When the drive belt is properly tensioned, tighten the four motor mounting bolts and replace the back cover.