laguna Sheartec II JX 8, Руководство пользователя, Страница: 18 / 47

18 JX|8 Sheartec:II Jointer \ Setup Assembling
BE CAREFUL WHEN WORKING ON OR NEAR CUTTERHEAD AS THE KNIVES ARE VERY SHARP!
CAUTION!
3. Insert three bolts, with the lock washer and flat washer into each hole of jointer body (Fig. 5). Thread
each bolt into the mating nut (factory secured) of the stand.
4. Use a wrench to tighten each bolt.
5. Attach the drive belt between the cutterhead pulley and motor pulley. Reach into the dust chute or
cabinet base, (depending on the model), and use a wrench to loosen the four bolts holding the motor to
the mounting bracket. Align the pulleys using the slotted holed on the motor mounting bracket.
6. Raise the motor as high as possible and mount the belt on to both pulleys. Allow the motor to lower and
create tension on the belt.
7. Pull down on the motor to achieve the desired belt tension. Correct tension is when the belt can be
deflected approximately ½” (1/4 ” each side of belt) at the center of the belt aspen using light finger
pressure (Fig.6).
FIGURE 6: BELT TENSION;
½” (1/4” each side of belt)
8. Tighten the four bolts mounting the motor.
9. Install the pulley cover using four ¼- 20 x ½” bolts through the cover and into the base. Shown in
Figure 7.
FIGURE 7: Pulley Cover
10. Clean all rust protected surfaces with a commercial de-greaser. DO NOT use acetone, gasoline,
lacquer thinner or any type of cleaner that could damage paint. Coat cleaned surfaces with WD-40® or
Teflon based lube.