17
.
ADJUSTING THE 45° & 90° BEVEL STOPS
1. Disconnect the machine from the power
source.
2. Raise the blade to its highest position and
lift the blade guard.
3. Loosen the bevel lock knob and turn the
blade tilting hand wheel clockwise until it
stops.
4. Verify the angle of the blade with a
combination square from the left side of
the blade, keep the square flat against the
table and against the flat part of the blade.
Do not touch the teeth or the table insert.
If the blade angle is incorrect, turn the 90° A
stop screw located on the table top to the left
of the blade until the blade is at the correct
angle. Fig. 22. Do not over tighten stop
screw.
Verify the 45° setting by tilting the blade as
far as possible to the left and using the
square check the angle and if needed adjust
as for the 90° stop, this time using the right
stop screw B Fig. 23.
ADJUSTING THE BEVEL ANGLE POINTER
The bevel pointer should read “0” when the
blade is at 90° to the table. If not, with the
blade set 90° vertical to the table, proceed as
follows:
1. Remove the hand wheel by loosening the
hand wheel lock knob A Fig. 24
2. Once the hand wheel has been removed,
loosen the cap screw on the pointer
mounting bracket with screw driver Fig. 25,
and manually align the pointer with the
zero on the bevel scale, then re-tighten the
screw and re-attach the hand wheel.
WARNING:
MAKE SURE THE SAW HAS
BEEN TURNED OFF AND UNPLUGGED FROM
THE POWER SOURCE BEFORE PERFORMING
ANY MAINTENANCE.
Fig. 22
Fig 22
Fig. 23
Fig. 24
Fig.
25
!
!
B
b
b
b
A
A
Содержание MTSAW17536110-0130
