laguna MTSAW17536110-0130, Руководство пользователя

Страница: 15 / 35

14
.
.
LEVEL THE FENCE
The fence should be parallel to the table and
sit approximately 2mm above the table’s
surface (so the fence will not scratch the table
and a thin work piece will not get stuck or
jammed under the fence).
To level and adjust the height of the fence:
1. Loosen the hex nut F on the leveling foot G
located under the rear end of the fence
Fig. 15.
2. Raise or lower the leveling foot until there
is a spacing of 2 mm (approx.) between the
bottom of the fence and the table, then
tighten the hex nut to lock the setting of the
leveling foot.
3. If needed, to level the fence, adjust the
plastic set screws E equally, thereby raising
or lowering the front of the fence an equal
amount on either side so as not to undo the
previous perpendicular adjustment Fig. 16.
ADJUST & ALIGN RIP FENCE POINTER
Set blade to 90° and raise it to the maximum
height. Move the fence till it lightly touches the
right side of the blade and push down the
locking lever to lock the fence in place.
With the fence locked in place against the
blade, loosen the pointer screws B Line up the
reference line on the pointer with the zero
point on the tape and re-tighten the pointer
screws Fig. 17.
Note: When changing blades, re-align the
pointer with the zero points on the tapes
to account for thinner or thicker blades.
DUST COLLECTOR
There is a 4" dust outlet located on the lower
left of the saw cabinet. This allows for the
connection to a dust collection system (not
included) Fig. 18.
1. Fit the 4" dust hose over the dust port, (not
included) and secure in place with a hose
clamp.
2. Make sure the hose could not come off.
Note: A tight fit is necessary for proper
performance.
WARNING: ALWAYS TURN ON THE DUST
COLLECTOR BEFORE STARTING THE SAW
AND STOP THE SAW BEFORE TURNING OFF
THE DUST COLLECTOR.
Fig. 15
Fig. 16
Fig. 17
Fig. 18
E
!
！