laguna MJOIN8012-0130, Руководство пользователя

Страница: 19 / 34

19
take all the teeth out and clean both the teeth and the mating surfaces again. This is
very frustrating, and a waste of time. Take your time and ensure that you are very
thorough with cleaning.
3. Lower the tooth into the cutter head and clamp with the allen key.
Note. Only move all the teeth to a new cutting edge. Do not move less than all the
teeth.
Note. The carbide cutter head will has several advantages over the parallel blade
type cutter head.
1. The teeth are carbide and will last longer than high speed steel parallel blades.
2. There is less chance of tare out.
The disadvantage is that they are initially more expensive and the surface finish is
slightly wavy. This is caused because the teeth have a very slight radius. This
waviness is easily removed by a light sanding.
Adjusting the fence.
90 degree stop
45 degree stop
The fence has 2 adjustable stops. One for
45 degrees, the other stop for the 90
degree position.
The fence is clamped in the angle position
with the clamp handle located at the side
of the fence housing assembly.
To adjust the fence, loosen the clamp
handle, move to the required position, and
re clamp.
The stops may not come pre set, and to
set, follow the guide lines below.
Adjusting the 45 degree stop
1.
Adjust the fence to 45 degrees using a
set square, and lock in position.
Forward back clamp handle
Angle clamp handle