laguna MJOIN8012-0130, Руководство пользователя

Страница: 17 / 34

17
If you need a longer cable than that supplied on the machine, you can connect a
new cable into the internal power termination.
Note. The machine is not normally supplied with an electrical plug, as the type of
plug will be dependent on the installation.
Running and adjusting the machine.
Cleaning the machine.
The machine is shipped with none painted surfaces protected from rust by a film of
grease.
The grease must be removed with WD40 or similar, as it attracts saw dust and dirt.
The surfaces should then be coated with a Teflon lubricant or similar. Teflon tends to
dry and will not attract saw dust and dirt.
Test Run.
Now that the assembly is complete it is time to conduct a test run.
During the test run you will check the following points.
1. Motor starts and runs smoothly.
2. That the stop button, function correctly.
Before you run the machine check the following.
1. All the tools have been removed from the machine.
2. That the guard is in place.
3. You are wearing the appropriate safety equipment.
5. You have read and understood the instruction manual.
Note. If any of the below functions fail to operate correctly, the fault must be
corrected prior to continuing to the next test. Any investigation to find or correct a
fault must be conducted with the power disconnected.
1. Start the machine by pressing the green start button.
The machine should run smoothly with little or no vibration.
2. Press the red stop button. The machine should slow down and stop.
Adjustments.
Note.
The machine has had all its functions calibrated at the factory but due to
shipping conditions, some movement may have taken place. This is unavoidable
and it is therefore recommended that the following checks are made prior to starting
production. As the machine is used some functions may move and it is therefore
good practice to know the process for adjusting the machine prior to production.
Adjusting the drive belts.
Adjust the belts so that there is approx 3/16 in deflection when pressed with
moderate finger pressure.
The drive belts should be checked after running the machine for approximately 10
hours. The belts bed into the pulleys, and will slacken off slightly. If they are not