laguna LT14 series, Руководство пользователя

Страница: 21 / 55

21
The switch is mounted on the main pillar of the bandsaw in the incorrect position for
operation. This is for transport reasons, and the switch will have to be moved to the
operation position prior to starting the machine. Remove the two screws, reposition the
switch box and reassemble the screws. Ensure that no strain is exerted on the cable during
this procedure. A qualified electrician must carry out the electrical installation. The main
connection should be made using the cable supplied and a plug (not supplied) to suit your
electrical supply. If you need a longer cable, you can connect a new cable into the switch
box, but this must be installed by a qualified electrician.
Ensure that the main supply corresponds with that of the machine, single-phase 220 V. If a
longer cable is required, use the below table as a guide for the cable gauge.
Distance wiring suggested.
1 phase 0-10 ft 12/3
1 phase 10-15 ft 10/3
1 phase 15+ ft 8/3
All
machines require the minimum of a 30-amp
circuit breaker.
Assembling the tool storage bracket
Install the tool storage bracket to the side of the
vertical frame as shown with the two socket head
screws and washers.
Before starting the machine
1.
Read and understand the instruction manual before operating the saw.
2. If you are still not thoroughly familiar with the operation of the bandsaw, get advice from a
qualified person.
3. Make sure the machine is properly grounded and that the wiring codes are followed.
4. Do not operate the bandsaw while under the influence of drugs, alcohol and medicine, or
if tired.
5. Always wear eye protection, safety glasses or a safety shield, as well as hearing
protection.
6. Wear a dust mask; long-term exposure to the fine dust created by the bandsaw is not
healthy.
7. Remove your tie, rings, watch and all jewelry. Roll up your sleeves; you do not want
anything to get caught in the saw.
8. Make sure that the guards are in place and use them at all times. The guards protect you
from coming in contact with the blade.
9. Make sure that the saw blade teeth point downward towards the table.
10. Adjust the upper blade guard so that it is just clearing the material being cut.
11. Make sure that the blade has been properly tensioned and tracked.
12. Stop the machine before removing the scrap piece from the table.
13. Always keep your hands and fingers away from the blade.
14. Make sure that you use the proper size and type of blade.
15. Hold the work piece firmly against the table. Do not attempt to saw stock that does not
have a flat surface facing down, unless a suitable support is used.
Tool storage bracket