laguna 14-Twelve Bandsaw, Руководство пользователя

Страница: 27 / 68

27
5. Wear a dust mask; long-term exposure to the fine dust created by the bandsaw is
not healthy.
6. Remove your tie, rings, watch and all jewelry. Roll up your sleeves; you do not
want anything to get caught in the saw.
7. Make sure that the guards are in place and use them at all times. The guards
protect you from coming in contact with the blade.
8.
Make sure that the saw blade teeth point downward toward the table.
9. Adjust the upper blade guard so that it is just clearing the material being cut.
10. Make sure that the blade has been properly tensioned and tracked.
11.
Stop the machine before removing the scrap piece from the table.
12. Always keep your hands and fingers away from the blade.
13. Make sure that you use the proper size and type of blade.
14. Hold the work piece firmly against the table. Do not attempt to saw stock that
does not have a flat surface facing down, unless a suitable support is used.
15. Use a push stick at the end of a cut. This is the most dangerous time because
the cut is complete and the blade is exposed. Push sticks are commercially
available.
16. Hold the wood firmly and feed it into the blade at a moderate speed.
17. Turn off the machine if you have to back the material out of an uncompleted or
jammed cut.
Electrical plug and cable
Motor data plate
The bandsaw is supplied pre-wired with a
110V 3-pin plug. It is recommended that the
bandsaw is connected to a 15 amp breaker.
The start/stop switch activates the motor
when it is pulled out and deactivates the
machine when pressed in. The switch can
be deactivated by removing the yellow
safety plug.
1. Close the doors.
2. Check that the red safety switch is in the
fully in position (Bandsaw switched off).
Safety plug
Start/stop
switch
Start/stop with
safety removed
Connecting the bandsaw to the electricity supply