laguna 14-Twelve Bandsaw, Руководство пользователя

Страница: 29 / 68

29
.
A lot of people do not like to change the blades and go to great lengths to avoid
doing it. To use the bandsaw to its greatest advantage, you will have to use the
appropriate blade and track it quickly. This is a habit that can be easily developed. If
you use a step-by-step method of tracking and tensioning, the procedure should
only take a minute or two. Be careful when using blades, especially wide ones.
Always use gloves and safety glasses.
1. Remove the throat plate by removing the clamp
screw.
2. Remove the table split clamp ratchet handle.
3. Remove the plastic blanking plate.
4. Adjust the side guide and back guide out as far
as they will go (both upper and lower guides). This
will ensure that they do not interfere with the blade
while you are fitting, tracking and tensioning the
blade.
5.
Uncoil the blade. Remember to use gloves and
safety glasses. The blade may have dirt or oil on it,
so use a clean rag to clean the blade by pulling
rearwards so that the cloth does not hook on the teeth
6. Inspect the teeth and the general condition of the blade. If the teeth are pointing in
the wrong direction when you hold the blade up to the machine, you will have to turn
it inside out. To do this, hold the blade with both
hands and rotate.
7. Slide the blade through the table split.
8. Open the blade guard door. Slide the blade
over the top flywheel and feed through the slot
at the side of the vertical column. Then feed the
blade into the blade guard slot and close the
blade guard door.
Clamp screw
Throat plate
Table split clamp screw
Table split clamp slot
Plastic blanking block
Blade in table split
Fitting a blade to the bandsaw
Disconnect the power from the bandsaw