Laguna Tools REVO 10, Руководство по эксплуатации

Страница: 14 / 24

14
1. Disconnect the power to the lathe.
2. Loosen the pulley clamp handle.
3. Move the pulley adjustment handle vertically as far as it can go and lock the
pulley clamp handle.
4. Move the drive belt to the required set
of pulleys. To access the lower pulleys
the electrical control box has to be hinged
away. The box is held in place with a
spring clip. Once the pulley selection has
been completed, the control box must be
clipped back in position. Never run the
late with the control box not clipped in
position, as the pulleys are dangerously
exposed.
5. Loosen the pulley clamp handle. Move
the pulley adjustment handle down to
apply tension onto the drive belt and
tighten the pulley clamp handle. The drive belt should be tensioned similar to a
car fan belt. Pressing on the side of the drive belt with moderate pressure, there
should be approximately 1/8" deflection.
6. Reconnect the power to the lathe.
Removing the rear face plate / spindle handle
Rear face plate Allen key Knock out rod
The rear face plate can be removed and another face plate (not supplied) fitted
as follows.
1. Disconnect the power to the lathe.
2. Loosen and remove the clamp screw with the Allen key.
Electrical control box
Access to lower pulleys