Laguna Tools REVO 10, Руководство по эксплуатации

Страница: 11 / 24

11
Fitting the tail stock rotating center
Ensure that the bore of
the tail stock is clean.
The rotating center has a
No. 2 Morse taper that
fits into the tail stock.
Push the center into the
tail stock bore firmly and
ensure that it is securely
located. To remove the
center, push the knock
out shaft into the back of the tail stock and give it a sharp knock. This will remove
the rotating center.
Note: Do not leave the knock-out shaft in the tail stock with the machine running.
Fitting the drive center in the head stock
Knock-out rod
Drive center
Ensure that the bore of the head stock is clean. The drive center has a No. 2
Morse taper
that fits into the head stock.
Push the center into the head stock bore firmly and ensure that it is securely
located. To remove the center, push the knock-out shaft into the back of the head
stock and then give it a sharp knock. This will remove the drive center.
Note:
Do not leave the knock out shaft in the head stock with the machine
running.
Rotating center
Knock-out rod