Laguna Tools PFLUX2, Руководство пользователя, Страница: 30 / 50

Mobile Dust Cyclone Manual
29
43. Install the intake splitter. For the
PFLUX2 install the 8
” by 6 ” reducer
or 8 ” by 4” x 2 ports to the intake
using (3) M4 x 12mm sheet metal
screws. Attach the rubber caps to
each 4” port.
For the PFLUX3 install the 8 ” by 4” x
3 ports to the intake using (3) M4 x
12mm sheet metal screws. Attach
the rubber caps to each 4” port.
49. All the assembly steps have
been completed.
POWER SUPPLY
Power Supply Circuit Requirements
The power source circuit for your machine must be g r o u n d e d and r a t e d f o r the
am perage given
below. Never replace a circuit breaker on an existing circuit with one
of higher amperage without consulting a qualified electrician to ensure compliance
with wiring codes.
If you are unsure about the wiring codes in your area or plan to
connect your machine to a shared circuit, consult a qualified electrician.
PFLUX2 (2HP/220V/60HZ/Single phase)
Circuit Size (220V).........20Amp
minimum
PFLUX3 (3HP/220V/60HZ/Single phase)
Circuit Size (220V).........30Amp
minimum
IN ALL CASES, MAKE CERTAIN THE RECEPTACLE IN QUESTION IS PROPERLY GROUNDED. IF
YOU ARE NOT SURE, HAVE A QUALIFIED ELECTRICIAN CHECK THE RECEPTACLE.
220 VOLT Single-Phase Operation
The motor supplied with your machine is a 220 Volt motor. It is shipped ready-to-run for
220 Volt operation.
PFLUX2
Serial# plate
PFLUX3