Laguna Tools MSANWB43X75-2RK-25-0197, Руководство пользователя

Страница: 9 / 43

INSTALLATION-
STEP 1. MOVING THE MACHINE STEP 3. POWER WIRE CONNECTIONS
The machine should be moved to the work site with a folk lift. Make sure Before connecting the power wires of the machine to the power supply, make
that the fork lift's loading capacity is adequate for the machine's weight. sure the voltage, hertz,phase and amperage are compatible. The prewired
The forks must protrude from the far side of the machine bottom when voltage of the machine is indicated on the electrical indication plate.
moving. Pay careful attention to the machine balance while it is being The power source connection points are located inside the control box and
moved, and make sure it does not strike the floor when being placed at the and are marked R.S.T. for 3-phase and R.S. for 1-phase. The ground wire
work site. connection point is marked "E". See Figure 1 .
Once the wiring is completed, turn the machine on, press the conveyor table
raising switch and see if the table moves the same direction indicated on the
switch, if it does not, turn the machine off and switch any two of the three
power source wires.
ELECTRICAL WIRING SHOULD BE DONE BY A QUALIFIED
ELECTRICIAN. THE MACHINE MUST BE PROPERLY GROUNDED TO
HELP AVOID ELECTRIC SHOCK AND ASSOCIATED HAZARDS
INCLUDING POSSIBLE DEATH.
STEP 2. CLEANING THE MACHINE
Anti-corrosive oil is applied to the machine before shipment. After
unpacking , using a cloth soaked in kerosene to clean the anti-corrosive
oil from the machine. Do not use lacquer thinner or any volatile solvents,
as they can damage the surface of the machine.
4
WARNING !!