Laguna Tools MSANWB43X75-2RK-25-0197, Руководство пользователя

Страница: 16 / 43

TROUBLE SHOOTING FOR DIGITAL PANEL:
POSSIBLE CAUSE SOLUTION
The display fails to show figures 1.Electric pressure of the 220V 1.Re-input correct electric pressure
or AC110V is abnormal 2.Replace 1A fuse
2. Fuse us burned out 3.Unit must be repaired or replaced
3. Control unit is out of order by authorized service personnel
Display shows abnormal figures 1. Wrong figures were input 1. Input the proper numbers in
2. Parameter is incorrect accordance with the actual dimensions
2. Caculate correct parameter and input it
*If the above steps are ineffective, turn
the power off and then on. If it is still
not working properly, it should be
repaired or replaced.
Display shows figures, but they do 1. Proximity switch is not 1. Change proximity switch
not change in conjunctions with functioning ( a functioning prox-
the hoist motor's operation. switch will cause the light on the
induction switch to be
illuminated or put out depending
on movement of the table)
2. Distance between induction 2. Adjust distance between induction unit
until and induction sheet is more and induction sheet to less than 1 mm
than 2mm.
3. Encoder not running in 3. Repair or replace Encoder
accordance with the table
movement. Axle connector off
or damaged.
4. Use Watt-hour meter to 4. Replace Encoder
measure if phase A.B. matches
the change of DC12V and 0V.
If phase A.B. has no change,
encoder is defective.
Travel dimension incorrect 1. Control unit parameter is not 1. Connect control unit parameter
in harmony with the table
11
PROBLEM