Laguna Tools MSANWB43X75-2RK-25-0197, Руководство пользователя

Страница: 19 / 43

V-BELT TENSION ADJUSTMENT CONVEYOR BELT
After the machine has been in operation for a long time, the V-belt The conveyor belt should always run at the center of the contact drum.If it
may become slightly loose. Should this occur, there will be an abnormal approaches either to the left or right, adjustment is necessary. First check that
sound while the motor is running. Adjust the V-belt as follow. the conveyor belt tension is correct. If the tension is too loose,adjust this first
Figure 11: Slightly loose the lock unit that tightens the motor base, and before you adjust the tracking.
turn the adjustment screw until correct tension is achieved. See Figure 12
Re-tighted lock nut.
CONVEYOR BELT TENSION:
1. Disconnect the sander from the power source.
2. Remove from brake cover by removing the four screw.
3. Turn both adjustment rod clockwise equally to increase tension.
CONVEYOR BELT TRACKING:
1. Turn the conveyor belt "ON"
2. If the belt is tracking to the right side of the table, turn the right
adjustment rod clockwise.
3. If the belt us tracking to the left side of the table, turn the left
adjustment rod clockwise.
THE EDGE OF THE CONVEYOR BELT SHOULD JUST TOUCH THE
GUIDE WHEELS.
Figure 11
14
Figure 12
NOTICE !!