Laguna Tools MJO6012-0800-1phCSA, Руководство пользователя, Страница: 16 / 33

16
2. Lift the tooth and rotate to the new cutting face.
Note: Take special care to clean the tooth and its matching surface. Any dirt or
sawdust that is trapped under the tooth will cause it to be at a different height to the
other teeth, and will degrade the surface finish when you start machining. This will
result in you having to take all the teeth out and clean both the teeth and the
matching surfaces again. This is very frustrating, and a waste of time. Take your
time and ensure that you are very thorough with cleaning.
3. Lower the tooth into the cutter head and clamp with the allen key.
Note: ALWAYS move ALL the teeth to a new cutting edge. NEVER move less than
all the teeth.
Note: The carbide cutter head has several advantages over the parallel blade type
cutter head.
1. The teeth are carbide and will last longer than high speed steel parallel blades.
2. There is less chance of tear out.
The disadvantage is that they are initially more expensive and the surface finish is
slightly wavy. This is because the teeth have a very slight radius. This waviness is
easily removed by a light sanding.
Adjusting the fence
Angle clamp handle
Forward / back adjusting
handle
Clamp handle
The fence can be adjusted to any angle between 90 and 45 degrees. To adjust the
angle, loosen the clamp handle, move the fence to the required angle and clamp in
position.
The fence has 2 adjustable stops, one for 45 degrees and the other stop for the 90
degree position.