Laguna Tools MJO6012-0800-1phCSA, Руководство пользователя, Страница: 13 / 33

13
11. Remove the side fixing screws from the jointer.
12. Loosen two casting mounting screws to loosen one of the black clamp blocks. It
is not important which side you choose. By loosening the clamping block it will be a
lot easier to attach the fence.
13. Lift the fence [this will take at least two people as the fence is very heavy] and fit
onto the jointer. Fit the side fixing screws and
tighten the side that was not loosened. Snug tight
the other side [loose casting mounting bolts].
Tighten the casting mounting bolts then fully
tighten the side mounting bolts.
14. Refit the cutter guard. When assembled, the
guard should move back to cover the cutter head
by the action of the spring. To obtain a smooth
action it is recommended that the guard is just
above the table. This will remove the friction of
the guard rubbing on the table.
15.
Connect a 5
” flexible hose between the dust
hose connector and your dust collector.
Once fitted pull on the hose to ensure that the
connection is tight.
Note: You will need a dust collection system
with a minimum of 1000 cubic feet per minute
capacity. The stronger the dust collection, the
better as the machine is capable of producing a
lot of waste.
The jointer is now fully assembled but before the
machine is connected to the electrical supply the
following checks and adjustments must be
carried out.
1. Check that the cutter head can rotate freely and that the teeth do not contact with
either the in or the out feed tables.
2. Check that the guard is covering the cutter head and that is free to move and
spring back once released.
3. Check that all tools have been removed from the machine.
Connecting the electrical supply
Note:
A qualified electrician must carry out the installation.
Ensure that the main supply corresponds with that of the machine.
It is recommended that you use a
30-amp mains breaker.
Note: The machine is not supplied with an electrical plug, as the type of plug will be
dependent on your installation.
Cutter guard
Dust hose connector