Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
983107-1
12
REV122021
ELECTRICAL CONNECTION
Safety Standards for electrical connections
Check that the electric supply system to which the machine is to be connected is grounded in
accordance with the relative safety regulations in force.
• Check that the power supply system is equipped with a circuit breaker to protect all
conductors from short circuit overloads.
• Before connecting
machine to the electrical system, check that the main voltage
matches the voltage indicated on the machine itself.
• Once connected, to avoid any possible residual risks of tripping and falling, make sure
that the power supply cable lies completely on the ground and is not at any point
raised in the air.
• The saw’s electrical system is fitted with a device which automatically opens the circuit
if the voltage drops below the minimum set limit and inhibits automatic reset of
operating conditions when the voltage returns to the set rated levels.
• Should the machine suddenly cut out there is no cause for alarm. Check that there has
not been a voltage failure in the main supply.
ADJUSTMENTS
Blade configurations, speeds and feeds and cutting pressure recommendations are printed on a
label affixed to the motor housing.
• Put the machine is safe conditions (see “GENERAL SAFETY REGULATIONS”).
• Wear protective gloves.
• At the end of every adjustment operation, check that all fasteners are securely tightened.
• At the end of every adjustment operation make sure no tools have been left on the
machine.
ADJUSTING BLADE TENSION
Machine with clutch:
turn the handwheel (2) clockwise until the clutch engages and clicks.
IF THE BAND TENSION IS TOO HIGH IT MAY JUMP OUT OF THE GUIDES.
