Lafayette Tenera Auto-Lift, Руководство по установке

Страница: 9 / 76

Tenera Installation Instructions 9 BACK
Mount the Installation Brackets — Outside Mount
■
Center the headrail over the window opening at the desired height. Use a pencil to lightly
mark each end of the headrail.
➤
Alternatively, measure the width of the headrail and use that width to mark the headrail
end points over the window opening.
■
Mark 2" in from each of the headrail end marks.
➤
If more than two installation brackets are required (see table on page 3), mark the
location of additional bracket(s) spaced evenly between the two end bracket locations.
Mount into wood whenever possible.
Allow a minimum of 18" from the motor side
for the battery wand.
■
Use pliers to break off both removable tabs from the installation
brackets.
➤
Save any removed top tabs for use as shims when needed.
■
Center the installation/extension brackets on your marks and
mark the location of the screw holes.
➤
The top of the installation brackets should be aligned and
level at the desired height
of the shading.
➤
If using extension brackets, center an extension bracket on your marks and mark the
location of the screw holes.
➤
A minimum 1" flat vertical surface is required to mount the installation or extension
brackets.
CAUTION:
The rear of the brackets or spacer blocks must be flush against a flat mounting
surface. Do not mount brackets on curved molding.
■
Drill the screw holes using a
3
/
32
" drill bit.
IMPORTANT:
Use drywall anchors when mounting into drywall.
Headrail End Marks
Window Opening
Motor
Side
18" Minimum for Battery Wand
Space Evenly Space Evenly
2" 2"
Installation Bracket
Removable Tabs