18
ADJUSTMENTS
TO SQUARE THE CUTTING
WHEEL TO THE TABLE
Do not loosen any screws for this adjustment until
you have checked alignment with a square and
made a test cut to ensure that adjustments are
needed for your tile saw.
This saw has been adjusted at the factory to make
accurate cuts. However, should your tile saw need
adjustment after it has been unpacked and
assembled or due to machine wear, the following
steps will be used to align the table to the saw blade.
NOTE:
Do not start any adjustment until you have
check alignment with a square and made a test cut
to ensure that adjustments are needed for your tile
saw.
Before performing any adjustments, make sure the tool is unplugged from the power supply and
the switch is in the OFF position. Failure to heed this warning could result in serious personal
injury.
fence and flat part of the blade.
Move the rail until the fence is square with the
FIGURE 30
FIGURE 31
FIGURE 32
A
FRAMING
SQUARE
B
A
A
18
