Lackmond BEAST10, Инструкция по эксплуатации

Страница: 10 / 65

10
ASSEMBLY
(continued)
ATTACH WORKTABLE
1. Position the slotted table lock (A, Fig. 8)
in the open position so that the groove is
parallel to the rails on the main frame.
2. Position the worktable (9) so that the two
left bearings (B, Fig. 8) on the bottom
engage, one over and one under, with the
left rail of the main frame. The wheel on
the right side of the worktable should ride
along the top of the right rail on the main
frame.
3. Slowly slide the table onto the rails,
pushing it all the way in.
4. Pull up on the the table stop (C, Fig. 9)
and rotate it 90 degrees until it clicks into
place. This will prevent the table from
sliding backward, off the main frame.
5 To lock table in place, so it will not move,
engage table lock (D, Fig. 9) into rail at
location shown.
ATTACH SPLASH TRAYS
The Beast 10-inch tile saw has two splash
trays, a smaller lower tray (2) and a larger
upper tray. (3)
1. Attach the lower splash tray first, by
engaging the formed cut-out (A, Fig. 10)
on the tray inside the water tray handle
(B, Fig. 10).
2. Gently press down on the splash tray
until it snaps into place.
3. Attach the upper splash tray by fitting the
cutout (C, Fig. 11) on the tray over the
mounting plate (D, Fig. 11) on the table.
4. Push the tray toward the table until it has
cleared the mounting brackets then push
down until the tray locks into place.
B
A
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
A
C
D D
B
C
D
11
ASSEMBLY
(continued)
ATTACH THE MITER GUIDE
1. Attach the miter guide (10) by engaging
the groove (C) on the underside of the
miter with the front rail.
2. Tighten in place using the miter lock
knob (D).
FIGURE 12
FIGURE 13
FIGURE 14
1. The table extension (12) installs on the
right side of the worktable.
2. Position the table extension so that the
two pins on the extension line up with the
two holes (A, Fig. 12) on the worktable as
shown.
3. Engage the pins on the extension with
the holes.
4. Secure the extension to the worktable by
tightening the thumbscrew (B, Fig. 13)
located on the bottom of the extension.
INSTALL TABLE EXTENSION
A
B
D
C
10