LabSat 3 Wideband, Руководство пользователя

Страница: 8 / 27

Page | 8 Revision 1.4 15 January 2015
Menu Layout
File
→ Info - Display file info for selected file.
→ Delete – Delete selected file Yes/No.
→ Format SD/USB – Erase and Format SD/USB Yes/No.
Constellation
→ GPS/GAL – Tick to select GPS/Galileo constellation for recording.
→ GLONASS – Tick to select GLONASS constellation for recording.
→ BeiDou – Tick to select BeiDou constellation for recording.
→ 2Bit – Record with 2bit quantisation when single constellation is selected.
Play
→ Loop – selected file will replay continuously.
→ Pause Time – Defines the pause time between each replay.
→ From – Specify a time in the scenario to replay from.
→ For - Specify how long the scenario will replay for.
Record
→ For -
Specify how long the LabSat 3 will record for.
Setup
→ Display – Adjust display contrast and backlight brightness.
→ RF Test – Outputs RF test signal.
→ Power Save – When selected, will power down display backlight and internal monitor during recording.
→ CLK REF
→ Internal - As the default setting LabSat 3 will use it internal reference clock.
→ External 10MHz – Allows the user to connect a 10MHz reference signal on the REF input.
→ Time – Configure internal clock using UTC time from internal GNSS monitor or set manually.
→ LAN
→ DHCP – Enable/Disable DHCP.
→ IP Address – Set the IP address assigned to LabSat 3.
→ SUBNET MASK - Set the Subnet mask assigned to LabSat 3.
→ DEFAULT GATEWAY - Set the default gateway for the network.
→ Digital
→ CH1
→ 1PPS – Record 1PPS signal from internal GNSS monitor (disable power save).
→ RS232 – Record RS232 signal.
→ CAN CH1 – Record CAN Bus channel 1.
→ DIGI – Record state of DIGI input signal.
→ CH2
→ 1PPS – Record 1PPS signal from internal GNSS monitor (disable power save).
→ RS232 – Record RS232 signal.
→ CAN CH2 – Record CAN Bus channel 2.
→ DIGI – Record state of DIGI input signal.
CAN
→ Record Type
→ Digitize – When selected the CAN data will be digitized and integrated into the .LS3 file.
→ Log File – When selected the CAN data will be logged into a separate .txt file.
→ CH1
→ Baud rate – Enables the user the set the desired baud rate.
→ Silent Record - Determines whether or not the LabSat sends an acknowledge pulse during
recording.
→ CH2
→ Baud rate – Enables the user the set the desired baud rate.
→ Silent Record – Determines whether or not the LabSat sends an acknowledge pulse during
recording.
About
– Contains information specific to the LabSat e.g. serial number & firmware version.
Exit
–
Return to file list.