LABORIE PORTASCAN 3D, Руководство по обслуживанию, Страница: 11 / 43

LABORIE Portascan3D Service Manual PTS3D-SM01 V3.0
7
1. Make sure that the probe and the main unit are well
connected and then click “SCAN” key on the main
interface. If the probe can work normally, the problem
may occur to the probe. Please identify the problem
with substitution method and replace the probe when
necessary.
2. If the above measure does not work, please open the
housing, remove the shielding cover and check probe
socket connecting cable. Identify the problem with
substitution method and replace the connecting cable
when necessary.
3. If the above measures do not work, the problem may
occur to main board. Please identify the problem with
substitution method and replace the main board when
necessary.
C. No Information is displayed when Probe Scans
1. Check if the probe cable is connected well with the
probe socket. If the probe is well connected, so
scanning with a normal probe. If there is a signal, the
problem with the probe can be identified. The probe
should be replaced to solve the problem.
2. If the replacing probe still produces no signal, then
please open the housing case, remove the shielding
case and check the signal cable at the soldered side
of the analog board and probe socket connecting
cable. If the problem is identified with substitution
method, please replace the connecting cable to solve
the problem.
3. If procedures 1. and 2. do not solve the problem,
please check if the connecting cable (shown in Fig. 8)
is well connected and identify the problem with the
substitution method. Replace the connecting cable
when necessary.
4. If the above-mentioned measures do not work, the
problem may be with the main board. Please identify
the problem with substitution method and replace the
main board if necessary.