Warning Label
Bottom of microscope
frame
A warning indication label is attached to every part where special precaution is required while handling and using
the microscope. Always read the warnings.
Warning label
position
[Warning against high temperature in
LED compartment]
[Warning against risk of electric shock]
[Warning against damage in non-
compliance with instructions manual]
If the warning label is stained or peeled off, contact your LABOMED distributor.
1. A microscope is a precision instrument with delicate glass components.
Please handle with care.
2. Do not use the microscope where it is subjected to direct sunlight, high
temperature
humidity
dust and vibrations. (For the operating
conditions, see chapter 13, "SPECIFICATIONS" on Page 22.)
3. The microscope is ventilated by natural convection. Be sure to leave
enough space (10 cm or more) around body while installing it.
4. Arm handle is provided for carrying the microscope.
,
,
To prevent damage, do not hold the microscope by the stage or
observation tube.
Be sure to remove the specimen from the stage clip while
transporting unit to avoid damage to the specimen slide.
1
2
Getting Ready
Maintenance and Storage
1. Clean all glass components by wiping gently with cleaning cloth provided. To remove fingerprints or oil smudges,
wipe with cleaning cloth slightly moistened with a mixture of petroleum (85%) and isopropanol (15%).
2. Do not attempt to use organic solvents to clean the microscope components other than the glass components. To
clean non-glass components, use a lint-free, soft cloth slightly moistened with a diluted neutral detergent.
3. Do not disassemble any part of the microscope as this could result in
malfunction or mitigated performance.
4. When not using the microscope, ensure that the frame is fully cooled
and store the unit in a dry locker or cover with a dust cover (provided).
5. To clean the condenser, fully loosen the securing knob (lower) and
remove the condenser by lowering condenser bracket, wipe the front
lens of the condenser with optical cleaning solution (mixture suggested
above) and lens tissue.
The condenser can be re-attached by replacing the condenser in its
seat, tightening securing knob, and raising condenser bracket to
desired position.
6. Be sure to observe your local rules/regulations for product disposal.
Since solvents such as petroleum and isopropanol are highly flammable, they must be handled carefully.
Be sure to keep these chemicals away from open flames or potential sources of electrical sparks - for
example, electrical equipment that is being switched “ON” or “OFF”. Also remember to always use these
chemicals only in a well-ventilated room.
Fig. 2
Fig. 3
!
3
Lx 100/200
Issue 1.0
5030000-795 User Manual Lx-100/200 Printed on July,2013
