The standard 10X eyepieces are clamped using screws.
1. Using allen wrench 1.2mm, loosen the clamping screw (1) from
the ocular tube and remove it.
2. Insert the optional eyepieces into the ocular sleeve and tighten
the clamping screw(1).
The microscope should be installed in any place that is not exposed
to direct sunlight. Direct sunlight reflection can cause eye injury, or
in some cases, blindness.
The eyepieces should be oriented toward the rear of the
microscope so that the reflection mirror receives unobstructed
light. To do this, loosen the observation tube clamping knob and
rotate the tube 180 .
1. Fit the reflection mirror in the window lens of the microscope
frame by aligning the mounting tab.
2. Remove the daylight filter because it renders the image blue
under natural light conditions.
3. The reflection mirror (fig. 5) should be pointed toward anywhere
with stray light. While observing the image through the
eyepieces, adjust the orientation of the reflection mirror to
capture stray light.
A plain reflection mirror is used normally. However, if the image
brightness is uneven or the outside view is visible in the image, use
a concave reflection mirror
c
3
2
Optional Eyepieces
Reflection Mirror
The reflection mirror is designed to be used in out door observation settings wherein a power source is not
readily available. The mirror attachment makes it possible to use natural light to illuminate your specimen.
1
Fig. 5
Fig. 6
Lx 100/200
12
Issue 1.0
5030000-795 User Manual Lx-100/200 Printed on July,2013
