BA_072_2020-02_10.00 Pressure transmitter PASCAL Ci4
Page 13/28
6.3.1 Displaying and entering parameters
When entering parameters, either numerical inputs or a selection lists with fixed options is
available.
In general, the actual selection will be displayed first (view mode). Press OK to switch to
edit mode to change the parameter. After this is done, the display will then switch back to
view mode so that you can check the new setting.
6.3.1.1 Selection of a value from a selection list
Up to three options are shown at the same time in one selection list. When the selection
list is longer, a scroll bar on the left side of the display indicates the position of the selected
item in the selection list.
When you press the ESC button, you cancel the entry and go back to view mode. The se-
lected value is not saved.
With the OK button, the selected value is saved. Saving the value is confirmed with an in-
formation window and the new value is shown in view mode.
With ESC, you leave the view mode and return to the menue.
Figure 10: Procedure for value selection (e.g. changing language from english to german)
6.3.2 Setting a numeric value
When setting numeric values, the screen shows the following elements (from top to bot-
tom):
Designation of the parameter that can be set
Help text (if applicable)
Numeric value and unit
Function of buttons
Bar graph
After selecting a menue item for numerical entry (e.g. damping), at first the value is dis-
played only. The numeric value itself is shown in square brackets and its unit behind it.
Unused leading digits are marked with bottom lines. You need to press OK again to enter
the edit mode.
Numeric values are entered digit by digit. First, always the leftmost digit is selected (visible
with a triangle above and below the number). By pressing OK, you go to the next digit.
