5. OPERATION:
Notes: Keep [Paper Cover Holder] closed before lifting Paper Holder.
Be careful not to have your fingers pinched in closing [Paper Cover Holder].
5-1 SETTING LAMINATING TAPE
1. Paste the tape onto a sheet of paper slightly
wider than the tape. The paper should be
approx. 180mm long.
Note: According to the width of laminating
tape, put the Width Setting Ring onto the other
side of the [tape core]. Paper Laminating Tape
85mm laminating tape : Ring width 12.5mm
98mm laminating tape: Ring width 9.5mm
124mm laminating tape: No Ring
2. Loosen the knob of [Tape Core] and thrust
the tape into the core as shown till it hits
the end. Tighten the knob to secure the
tape in position.
Tape Core Knob
Accumu-Section
3. Bring down the Accumu-Section backward,
draw out [Tape Core Holder] and place [Tape
Core] on it with the knob this side.
Then push the holder back into position.
Tape Core Holder Knob
4. After [Tape Core Holder] was placed into
position, draw out [Tape Core Holder Pressure
Plate] and hook onto [Tape Core Holder].
Tape Core Holder Pressure Plate
9
