LaBina Mini, Инструкция по эксплуатации

Страница: 8 / 26

88
Setting up the control unit
Always place the control unit and the handpiece with the handpiece holder on
a secure, firm and level surface.
It must be guaranteed that the pigmentation device can always be operated
during use
.
NOTE: Protect the pigmentation device from being dropped
Damage may occur as a result of the control unit or handpiece
being dropped.
Connecting the AC adapter
WARNING: Risk of short circuit and electric shock
Due to excessive mains voltage, faulty electrical installation or
improper handling.
Only connect the control unit to a properly installed power socket.
The mains voltage must always match the input mains voltage shown on the
AC adapter type plate!
Only connect the AC adapter to an easy to access power socket so you can
quickly disconnect the power supply in the event of a malfunction.
Do not use any damaged equipment or accessories. Damage to cables or the
equipment significantly increases the risk of electric shock.
Ensure that all plugs and cables are clean and dry. Never connect the
pigmentation device cables using damp hands.
Figure:
Front of the control unit Figure:
Back of the control unit
Connect the power supply for the control unit in the following order:
Plug the connector from the AC adapter power cable into the green power
connection socket on the back of the control unit.
Then plug the supplied AC adapter into the power socket (230 V).
Once the power supply has been
connected, the LED indicator lights
up with the preset voltage of 6.5 volts.
This voltage corresponds to an average
stroke speed.
The LaBina ® Mini handpiece is equipped
with a DC motor with an output of 5.5
watts and supplies the handpiece with
a voltage of 0 to 12 volts.
Using the pigmentation device for the first time